常州亿创钣金加工厂专业从事精密钣金加工、激光切割加工为主的钣金加工型厂家

常州亿创钣金加工厂

示例图片三
网站首页 > 行业资讯 > 行业知识

如何判断机柜钣金加工质量的好坏

2018-05-08 09:28:12 常州亿创钣金加工厂 阅读

一看机柜表面钣金加工的喷漆,好的机柜所有的钢材都需要喷漆,而且要喷的均匀,这样才能做到很好的防锈和防尘。

二看钢板的厚度,只要用手指敲一下就知道钢板的厚薄了,还有机柜内部的支架也是粗点的好,因为有时候里面装的设备比较重,要是太细的话看就承受不了设备的重量了。

三看玻璃,玻璃也要厚一点,特别要注意看玻璃的周边有没有裂痕,如果有的话建议还是别要,还要看玻璃是否棘手。

最后看机柜里面的配件,如果机柜带有电缆管理模块使电缆可以直接固定在垂直安装轨内,则再好不过。无论哪种情况,机柜内部的上壁和侧壁应当

有足够多的固定环(来保护电缆),也可以通过把机柜底板上抬,以便下面走线。还有一些用来固定机架的螺丝、螺母等,也要足量。这样可以避免日后扩展而带来配件不足的麻烦。

Look at the spray paint on the surface of the cabinet. All the steel in a good cabinet needs to be painted, and it needs to be sprayed evenly. In this way, a good rust proof and dustproof can be achieved.

Two to see the thickness of the steel plate, as long as the finger knocks to know the thickness of the steel plate, and the internal frame of the cabinet is also a good point, because sometimes the equipment is heavy, if too thin, you can not bear the weight of the equipment.

Three to see glass, glass is also a bit thicker, especially to see whether there is no cracks around the glass, if some, it is not necessary to suggest, but also to see whether glass is difficult.

Finally, look at the fittings inside the cabinet. If the cabinet has a cable management module, the cable can be fixed directly in the vertical installation rail, but it is no better. In either case, the upper and side walls of the cabinet should be

There are enough fixed rings to protect the cable, or you can lift the bottom of the cabinet to lower the line. There are also some screws and nuts for fixing the rack. This can avoid future expansion and bring inconvenience to accessories.


标签:   钣金加工 钣金机箱加工 钣金机柜加工