常州亿创钣金加工厂专业从事精密钣金加工、激光切割加工为主的钣金加工型厂家

常州亿创钣金加工厂

示例图片三
网站首页 > 行业资讯 > 行业知识

工业铝型材锯切装框时应注意的事项

2018-05-25 21:57:34 常州亿创钣金加工厂 阅读

工业铝型材装框时,注意对悬臂比长型材,壁薄材,圆弧材,开口材,实心小截面材,板材,表面高要求材,互扣,自扣或不易分离的型材等要注意装框时的方式和方法,以及必要的辅助工具,衬纸衬套等。垫条要上下对应,排列正确,间隔适当,数量合适,能承受工业铝型材质量和一定的加力,不能过多堆放叠放。需架空装框的型材必须架空堆放。
When the industrial aluminum material is framed, attention should be paid to the way and method when the frame, such as the long section of the cantilever, the thin wall material, the circular arc material, the open material, the solid small section material, the plate, the high requirements for the surface, the interlocking, and the non easy separation, as well as the necessary auxiliary tools, the lining paper bushing and so on. The pads should be arranged on the upper and lower sides, with the correct arrangement, suitable spacing and suitable quantity, which can withstand the quality and certain afterburner of the industrial aluminum profile. The profile of the frame must be piled up.

注意工业铝型材堆放在框中的位置,避免两头轻重,造成型材起堆、滑落等事故。注意锯切速度,锯切面毛刺情况,观察锯床喷油大小加以调整,注意锯床压料情况。锯切操作时要注意力集中,避免人身安全伤害事故。锯切时严禁在型材两外侧用力,避免在切锯中型材夹锯,造成打料动作发生进而瞬间既损料又伤人。
Attention should be paid to the position of industrial aluminum materials stacked in the frame, so as to avoid the weight of both ends, resulting in accidents such as stacking and sliding of profiles. Pay attention to sawing speed, burr of sawing surface, observe the size of the sawing oil and adjust the material of the saw. During the sawing operation, attention should be paid to avoid accidents of personal safety and injury. During sawing, it is strictly prohibited to exert force on the outside side of the section two, so as to avoid cutting the saws in the cutting saw, causing the material to take place, and instantly damaging the material and hurting people.

注意铝屑要吹净,毛刺要刮除,间隔要适当,吊运要安全,叠框要对齐,叠框数量不能超过公司规定的四层数量要求。

Notice that the aluminum scrap should be blown clean, the burr should be scraped out, the interval should be appropriate, the lifting should be safe, the stack frame should be aligned, and the number of stack frames should not exceed the requirements of the four layer quantity stipulated by the company.


标签:   钣金加工